M E A S U R I N G   I N S T R U C T I O N S   C O N T.

Angle Top Blind
• The maximum angle for a verticle blind to both rotate and traverse is 18� to 45� - rotation only. For angles greater than 30� extender hooks (shown bottom left) must be used for louver clearance.

• Controls must be at highest point on the window. Blind is available only as one way draw to the high point.

• Track measurement will begin at lowest corner.

• The corner of the track will touch the side of the window casement about 1-1/4" from the top. (Point A) Specify measurement from this point. (Figure 2)

• The factory will make each vane to the longest length. Vanes will be cut to length at time of installation.

• Specify angle top blind in Special Instructions on your quote form.

Ordering Valance

• The valance for angle top blinds mounted inside must be ordered 4" longer than the track width. The angle of the end of the valance must be cut at the time of installation.

• The valance for angle top blinds mounted outside must be ordered 6" wider than track width and can only have returns if the ends are not cut to match the angle of the window.

Ordering Angle Bottom Blind

• Track is measured the same as standard vertical blinds.

• Measure the longest drop. Each vane will be made the the longest drop and must be cut to size when installed. (Figure 3)